Kadet Whole-Milled Fillet Clamps

TS-PT2100310
89.00
TSPROF Kadet whole-milled fillet clamps are designed for fixing knives with a spine thickness of up to 3.5 mm, on a TSPROF Kadet Expert sharpening system. The radially convex shape of the outer surface allows you to set the minimum sharpening angles of less than 7.5° per side.

The clamps are supplied with; two types of screws:

Shortened, designed for sharpening thin knives, at minimal angles;

Standard, designed for knives with a spine thickness of up to 3.5 mm.

The clamps are made of a single piece of aviation aluminum, allowing you to adjust the clamp to any shape of the blade and ensure the symmetry of the installation. Thanks to the two gripping points, the deflection of the blade is impossible. It is possible to independently move the clamps along the entire length of the frame. There is no need for calibration. With these clamps, it becomes possible to sharpen knives with "Scandinavian bevels" along the line of bevels. They are suitable for kitchen and fillet knives with a narrow spine, keychain knives, straight razors, knives with "scandi-descents", etc.

Characteristics:
Clamp length:100 mm
Minimum angle: 8.5°
Recommended blade length: 30-200 mm
Jaws tips thickness: 1 mm
Clamp width: 20 mm, 2 pc.
The gap between jaws in the free state: 4 mm
Maximum spine thickness of a knife: 3.5 mm
Size for a wrench: HEX4 hexagon 4.0 mm
Wrench: included

The clamps are designed for the TSPROF Kadet sharpening system.